Check the listing for details. 10-degree Tool Holder for Ryobi 18v One+ Tools for Wall, Pegboard, or Ryobi Link. Color: Green, Condition: New. Listed at 12.95 USD. GREEN Ryobi 18v One+ 10-degree Post Tool Holder for Wall, Pegboard, or Ryobi Link Wall Rails Ryobi 18v One+ 10-degree Post Tool Holder for Wall, Pegboard, or Ryobi Link Wall Rails This Tool Holder holds one Ryobi One+ Tool at a 10-degree angle and works for a wide variety of Ryobi 18-volt One+ tools (drills, drivers, inflators, flashlights, multitools, etc.). It will not hold large, heavy, or oversized tools (such as blowers, nail guns, staplers, saws, weed eaters, etc.). The post base is connected to wall bracket with a screw and bolt that allows it to be repositioned in 4 directions. The post is long and offset enough for tools to be mounted with a belt clip attached (see photos of Impact Driver). There is a notch on 3 sides of the base to help accommodate an electrical cord for hybrid tools white mounted. A screw and nut are included to reposition the base. Edges are mitered to be smooth and durable. The back is designed to mounted in a variety of ways including screws to the wall, pegboard* with holes at 1" on center, and Ryobi Link Wall Rails. If mounting to the wall or surface with screws, the pegs stay recessed on the back and are not used. If mounting on pegboard*, pry pegs (with a small flat screwdriver) out and push into the holes. 2 curved pegs go into the top holes pointing upward and 2 straight pegs go into the bottom holes. We recommend you superglue them into place. 2 extra pegs (one curved & one straight) and screw & nut are included. No tools are included and shown in photos for reference only. * Note that there are many different types of pegboard and some may not work. This was designed to work on 1/8" thick masonite pegboard with holes at 1" (25.4mm) on center only. If you previously purchased this item in when it was printed in PLA plastic , please note that PETG is a stronger filament and better for higher temperature environments. PETG also has a slightly shiny finish. Please let us know if you want your order to be in PLA to match any previous purchases. It is 3D-printed in PETG plastic. It is 2.42" x 3.9" x 3.52" (62mm x 100mm x 90mm). This item is 3D Printed in PETG plastic which is made from a renewable resource. It’s biodegradable and eco-friendly. These are lightweight and due to the printing process, there may be some imperfections. 3D Printing involves the heating and depositing of material on a flat board one layer at a time. Each model is custom printed to order. We print these as a hobby and are not a large scale manufacturer. They are all printed in the USA