Check the listing for details. 3D Printed FPV Race Drone Frame by MikeTheSpike02. Color: Black, Condition: New. Listed at 15.00 USD. This is a fully 3D printable 5 inch drone frame. It weights 94 grams when printed in PETG, competing with similarly sized carbon frames. Admittedly not as durable, but much more replaceable. (Though it can be printed in much stronger materials than just PETG) It accepts a 20 x 20mm stack under 16mm in height. The top plate is attached to the main body using four of each of the following: 6mm M2 bolt, 8mm M3 bolt, M2 insert nut, M3 insert nut. An additional two 8mm M2 bolts were used to mount the camera. Color will come in black. Material will be made out of PETG+ Carbon Fiber Recommended Components: 4PCS Airforth AF2205 2205 2300KV 3-4S Brushless Motor CW for RC Multirotor Airplane FPV Freestyle Drones DIY PartsAny 5 inch propsNOXE F4 V3 FC / F3 / Aocoda-RC F7 V1.0 Flight controller / Mini 35A 4 in 1 ESC / XF5806 Flytower For FPV RC Drone ELF88 90 Q90 or any 20 x 20 mm flight stackFPV System Combo 1200TVL Camera + 5.8G 40CH 600mW Transmitter with Microphone Wide Voltage for RC Quadcopter FPV Racing Drone1.7g Fli14+ Fli14 Plus 14CH Mini Receiver Compatible Flysky AFHDS-2A with RSSI Output for FS i6 i10 i6x Turnigy I6S RC Drone or any mini receiverM2 Insert NutsM3 Insert Nuts M2.5 Bolts