Check the listing for details. 3Pcs Tomahawk Eye Drift Mandrel Blacksmith Tool Handle Hawk Maker Hammer Forging. Condition: New. Listed at 58.45 USD. 3Pcs Tomahawk Eye Drift Mandrel Blacksmith Tool Handle Hawk Maker Hammer ForgingFitment:These are being used by many master hawk makers. Suitable for blacksmith, hawk makers and so on. Fit most handle suppliers The drift is tear drop shaped to form the hole needed to handle hand made tomahawks, hammers, etc. Use the handle to fix and extend drift for easy hammer forging. The bolster plate is used for making wrapped tomahawk eyes or drifted eyes if proper opening slit is made. These must-have drift tools for blacksmiths will help you get the job done easier and faster, improving efficiency and quality Features: 1) It's a full set for you to forge your hand-made Tomahawk, the handle and bolster plate match the drift as a fixed bracket for easy operation 2) Made of heavy-duty steel with anti-rust and heat-resistant coating, the tools are used to form the hole needed to handle hand-made hammers, axes, and tomahawks as you want 3) The dimension of the drift is 10.8 inches in length. The handle is 7 inches in length. The bolster plate is 3.6 inches in length and 2.99 inches in width 4) 1) Drill a series of small holes close to the center of the workpiece to be drifted. 2) Once the holes are drilled, heat the piece and split with a cold chisel or similar tool. 3) Then, the piece is heated again and the drifters are driven into the holes. 4) While continuing to drive the drifters into the workpiece, tap the sides of the workpiece until the drifters' holes reach the desired measurement. The heating process may take several times to obtain the desired shape Package included:one iron drift, one handle, and a square bolster plate