Check the listing for details. 6 LED warm white light cable & effects control & 9V clip props scenery MELWW6XD9. Condition: New. Listed at 25.99 USD. 6 Micro Effects Light 6 Warm White Daisy Chain Cable 28 Inch & 9 volt battery Clip Easy assembly; plugs together and operates on 9 volt battery The MEL-WW1 LED Lights are easy to use for various projects. Daisy Chain Cable: DC barrel connector male plugs 6X at 4 inch ref. (102mm ref.) spacing for 20 inch ref. (508mm ref) effective length for lighting applications, Overall Length: 28 inch ref. ( 711 mm ref.) including input jack and output plug. 6 pcs MEL-WW1 (Warm White), LED Light 1 pcs Daisy Chain Cable, with plugs for 6 MEL lights and 1 input jack and 1 output plug1 pc MED1 effects controller dimmer 1 pc BCC1-9V, 9 volt battery clips If you need another color we have; warm white, red, green, blue, amber, orange, and purple / magenta send a message. Well suited for various LED lighting applications such as: Scenery / Props / Models / Animatronics / Robotics Fx- Special effects / costumes Theatrical stage and set obstruction marking Theming, décor lighting and promotion display products Amusement, arcade, gaming and entertainment lighting Specialty miniature accent lighting, micro fixtures Sales and trade show displays and signage Technical Info: The MEL (Micro Effects Light) is a series of simple low cost LED light sources with a built in DC barrel type connector. The MEL operates from 9 – 12 volts DC which allows a simple effects system operating from a 9 volt battery possible. Each MEL is optimized for high light output at 9 volts DC with a nominal power of 0.18 watts operating at 20ma ref. The LED lens is water clear with a 30 degree output angle for a narrow beam. The axial body of the MEL LED is of a small size and molded in black ABS resin. The MEL body overall length is 1.42” (36mm) and the diameter is 0.48” (12.2mm) nominal. The P/N MED1 Micro Effects Dimmer provides dimming, multimode effects, and on / off control of 5 – 24 volt DC LED lights. The unit features a simple tactile three button interface; Light, Speed, and Mode. The variety of effects combined with the simplicity of use makes this a great control for low complexity projects. The Light button is used in static mode for dimming. Note the Static (0 mode) dimming function is between effects #8 and #1 when sequencing through the modes. The Speed (On/Off) button provides ten speed levels for the effects modes and is also used to turn the unit off when it is held longer than 3 seconds. The Mode button provides eight dynamic effects, and the Static (0 mode) between effects #8 and #1. Mode effects patterns 0) Static mode for dimming 1) Up / Down – ramp up on ramp down off – repeat 5) Blinking – long on 2) Up / Down – flame flicker – always on 6) Flash - burst of pulses (emergency vehicle light) 3) Strobe – fast 7) Strobe – slow (beacon light) 4) Blinking – long off 8) Up / Down varying brightness – brief off – repeat The MED1 body measures a nominal 1.4” length, 0.6” wide and 0.2” thickness. Each of the connector cables extends from the body 5.5”. The overall end to end length of the entire body and cable assembly is 13.0” Max. The unit’s body is sleeved in black and the cables are molded in black PVC.