Check the listing for details. Drill Attachment Adapter, Impact Fit, Max Torque 500, Use with Cordless Drill. Color: Silver, Condition: New. Listed at 35.99 USD. Product DescriptionKey FeaturesApplicability2-inch front-to-back designCompact design for driving screws and drilling holes in tight, difficult work areasDurabilityAll metal housing for maximum durabilityThe support arm provides security and a comfortable grip. It can help you save time and get the job done easier.Nice TorqueUp to max. 3000 RPM and 443in-lbs (50 Nm) of torque.For use with cordless drill and impact driver up to 18 volts.Key FeaturesGood Flexibility360° Collar Rotation150° Support Arm RotationThe support arm can be adjusted to 40 positions ( 8 positions around the head of right angle drill attachment, each has 5 side angle positions).High CompatibilityCompatible with a wide variety of 1/4 inch HEX Shank AccessoriesDrill BitsSpade BitsNut DriversDrill ChucksBefore UseNote:When adjusting the position of the support arm, align the edge of right angle drill attachment head with the edge of the adjustment collar. Otherwise, the support arm will be stuck. With drills up to 3,000 RPM, the support arm can be adjusted to 40 positions ( 8 positions around the head of right angle drill attachment, each has 5 side angle positions).Warning:To reduce the risk of injury, the support arm must be securely tightened in the detent position. Otherwise, the adjustment collar would rotate when used.The angle attachment is for use with cordless drills and impact drivers up to 18 volts. Never use the attachment with impacting tool or corded tool.How to useMake sure the adjustment collar is on the “free rotation” position.Rotate the adjustment collar until the support arm is in the desired position (45° increments).Unscrew the support arm 2 full turns. Position the support arm to the desired angle( 30°increments). Tighten the handle securely.How to useInserting Bits1. Insert the bit shank into the chuck.2. Pull on the bit to make sure it is secure.3. Pull down the chuck collar and release the bit shank.Operation:Make necessary adjustments to support arm. Hold the power tool securely to control the torque reaction. Place the bit against the workpiece, maintaining 90°angle between the right angle drill attachment and the workpiece. Start the tool slowly, gradually increasing speed.WARNING:To provide maximum control, please adjust the support arm before using it. Never use the right angle drill attachment with the support arm loose.Hold the tool securely and tightly when drilling/driving to control the torque reaction. Be careful that high torque situation may cause the tool to spin, causing loss of control.