Check the listing for details. Hobart Mixer Switch and timer (Etched) C100T Control plate, With Safety Post. Condition: New. Listed at 56.00 USD. Hobart mixer C100T control plate with 15 min. timer, 115 volts. Comes with New mounting screws, timer terminals, and switch terminals. Plate markings are etched into the surface. Safety post for on/off switch , Mylar insulator for timer. This is the final version Hobart used on the C-100T. If you have the older version spring wound timer this will work with neutral hooked to the unattached lead on timer motor.Markings are etched into plate for durability, Unetched markings cannot survive many cleanings with the mighty Scotch-Brite pad as it is basically a flexible sand paper. No markings makes for a unsafe mixer!Switch is factory spec with neoprene o-ring seal on toggle paddle to prevent water from entering switch.Plate has safety post to help prevent accidental turning on of mixer as this is critical on the C100T with the timer and shifter so close to the on off switch.Switch has neoprene o-ring seal to prevent water from entering switch. Factory spec switch is critical. This is the final factory spec version for the timed C100TNote: all wires must be run over the top of timer to switch and timer terminals, they cannot be on back side of timer as Hobart left no room. If you have any questions please ask before you buy.Thanks!