Check the listing for details. Prince August Starter Kit Hobby Casting Equipment - PA2000 - Essential tools.. Condition: New. Listed at 19.70 USD. This starter kit contains all of the basic hobby casting accessories you will require to cast, just add your chosen moulds and casting alloy, to start white-metal casting as a hobby. Note you will also need a heat source like a domestic cooker to melt the metal. Contents: Casting ladle. This will contain the liquid metal and let you pour it into your chosen mould. Small pot of release powder (approximately 7 grams of powder). This is pure talcum powder that is applied on the surface of the mould to allow air to escape and prevent metal sticking to the mould. Includes a cotton swab for application. 3 sets of different sized support boards (suitable for any mould). Boards sandwich the rubber moulds to help spread the pressure from the clamps. 2 mould clamps. These go on either side of the assembled mould and boards to hold them together. Casting guide. Hobby Casting is easy to learn and usually it takes about five minutes to cast a figure once the metal is ready for pouring. The metal used for Prince August moulds cannot require higher temperature than 450 degrees Celsius. SHIPPING INFORMATION: We ship any orders received from Monday to Friday, 9 to 5 p.m UTC. We are shut Saturdays, Sundays and Irish Bank Holidays. Any orders or questions sent in will be dealt with the next work day. Shipping in European Union can take up to 21 days. COMBINED POSTAGE: We will gladly combine postage for moulds and accessories, please contact us for a quote, due to the weight of many of these items we need to know your postal destination and quantity wanted before offering discounts. CASTING WARNING: Metal casting is NOT a toy. Prince August Metal are recommended for children over 14 years. Adult supervision is needed. Protect worktops from hot metal by covering then with a newspaper or a sheet of hard board. Any spilled metal can be removed after it cooled down. Do not cool down the metal or mould with water. Explosion Risk!. Moulds and metal taken from cold storage should be allowed to warm up before use by leaving them in a warm room. Safety tested under En71.