Check the listing for details. Sherline 3/8 in Drill Chuck with two Arbors 1069. Condition: New. Listed at 89.79 USD. Sherline 3/8 in Drill Chuck with two Arbors 1069 Sherline 3/8 in Drill Chuck with two Arbors 1069 We supply a #0 Morse arbor for use in the tailstock for center drilling. They are available in 5/32, 1/4 and 3/8 sizes. Runout is .003 or less. If runout of less than this amount is required, collets should be used to hole the drill rather than a chuck. This larger drill chuck will hold drills from 1/32 (.8 mm) to 3/8 (9.5 mm) in diameter. Because of its longer length and ability to hold longer 3/8 drills, it is normally recommended for use on the longer 4400-series lathes. It comes with a #0 Morse arbor for use in the tailstock. Also included is a #1 Morse arbor and drawbolt so the chuck can be used in the lathe or mill headstock as well. Shipping Delivery time: To keep shipping costs as low as possible we ship USPS Ground (7-10 day) Payment We accept the following payment methods: Paypal Service International Shipments: We cannot guarantee any specific delivery times.